Juniper interface/vlan/ip

-

 Juniper interface:

        Two type of juniper interface

                                1. Network interface

                                2. Special interface

Comments

Post a Comment

Popular posts from this blog

inter vlan routing on cisco router and switch

-
Image
VLAN and IP Configuration on Cisco Router: Router(config)# Router(config)#interface gigabitEthernet 0/0.10 Router(config-subif)#encapsulation dot1Q 10 Router(config-subif)#ip address  192.168.0.1 255.255.255.0 Router(config-subif)#exit Router(config)#interface gigabitEthernet 0/0.20 Router(config-subif)#encapsulation dot1Q 20 Router(config-subif)#ip address 192.168.1.1 255.255.255.0 Router(config-subif)#exit Router(config-subif)#interface gigabitEthernet 0/0.30 Router(config-subif)#encapsulation dot1Q 30 Router(config-subif)#ip address 192.168.2.1 255.255.255.0 Router(config-subif)#exit Router(config)#exit Router# VLAN  Configuration on Cisco Switch: Switch>ena Switch#configure  Switch(config)# Switch(config)#hostname SW1 SW1(config)#vlan 10 SW1(config-vlan)#exit SW1(config)#vlan 20 SW1(config-vlan)#exit SW1(config)#vlan 30 SW1(config-vlan)#exit SW1(config)#interface gigabitEthernet 0/1 SW1(config-if)#switchport mode trunk...
Read more

Mikrotik Hotspot Configuration

-
Image
  Mikrotik Hotspot Configuration Initial Setup If you’re using a new Mikrotik router, we recommend resetting the device to remove the preinstalled configuration as it contains settings you will probably not need. You may also need to upgrade your RouterOS to the latest stable version, from mikrotik.com. If you are using a Mikrotik that’s already running in a production network, we suggest that you make a backup of your current configuration. Go to Files > Backup, then click to backup your current configs to the file. Optionally drag-and-drop the new backup file to your desktop to save it locally. Adding IP Addresses to the Mikrotik Add an IP for your Hotspot network by going to IP > Addresses. Ensure you assign the IP address to the proper interface on which the switch or AP for the hotspot network will be connected. It is also best practice to put comments on the newly added subnet . Configuring the Hotspot Server To configure a hotspot server, follow these steps: Click IP ...
Read more